A good friend recommended I post here and to put as much information as possible so sorry if this a bit too in depth! Also, I don’t like the flimsy micro USB cable powering it – very easy to come out. Submit a new text post. Sooo it would appear its to do with windows update Welcome to Reddit, the front page of the internet.
|Date Added:||10 July 2008|
|File Size:||26.48 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
This post has been edited by harrison Page 1 of 1 You cannot start a new topic You cannot reply to this topic. The maxi really is the way to go and they’re discontinued now.
Blue Room technical forum: Chamsys & Enttec Driver Problem – Blue Room technical forum
If you plan on trying out different software, go Enttec. Submit a new text post. As for the DMX addresses? If you can afford it, buy the Enttec or the more expensive Chamsys dongle. Welcome to Reddit, the front page of the internet. Please note this is all chammsys kit I have available to me, anything else will need to be bought before the show tomorrow evening.
Problems with MagicQ using ENTTEC DMX-USB Pro mk2 – Blue Room technical forum
I didnt know to enable universe 1 in MagicQ and set the output type to Enttec Pro. I am running the channel desk demo program that is in the demo file when I go to load show, and when I bring up 1 THRU FULL not a single par can goes on despite the software saying that they should be.
I am running from the 3-plug breakout cable on it through DMX1 out 5-pin femalethrough a neutrik 5 pin male to 3 pin female converter and into a 3 pin male which snakes up to the lights above the stage.
Posted 05 December – Two things to check: I personally have the unlimited Chamsys dongle. Submit a new link. Cbamsys used a chamsys dongle in the past, never had it lock up or lose connection, but I worry about the flimsy cable and strain relief pulling apart over time.
Sooo it would appear its to do with windows update It should say ‘successfully removed device from this system’. Welcome to Reddit, the front page of the internet.
Any reason to purchase Chamsys dongle vs Enttec Pro? This post has been edited by Tom Baldwin: I might have an addiction.
Chamsys & Enttec Driver Problem – Blue Room technical forum
If Chamsys say it should work, then it should work. If anybody needs to know more, I’ll be watching this thread intently! Then, being new to the software I had problems patching the dimmers but eventually I got there Dec 29 I have ran the robedemo sample shows that were suppled and I have had fun playing around with them in the visualiser version.
The one for 3k?
Submit a new text post. I never used Chamsys dongle. This was on a post I had a few days ago, I will say it works but you cannot connect back to wifi with the enttec connected after you successfully install the new driver. Any ideas as to if something is wrong here or am I missing something fundamental?
I cannot get the lights in the venue to work using my setup, however the GLP showdesigner in the venue does work though only partially as someone has pulled all the sliders off